Drawmer MC2.1 Monitor Controller - Manual (Page 15)

1 5 MC2.1 - Monitor Controller
MAINS I.E.C. AND POWER SWITCH
The mains inlet, I.E.C., which also incorporates the internal mains fuse, can be
found on the rear of the unit. A mains lead will have been provided with the MC2.1
to suit the mains configuration for the country of your purchase.
The power switch is located above the I.E.C. and is used to switch the unit on and
off. This is a hard boot switch (as opposed to a soft stand-by switch) and so when
in the off position the MC2.1 will draw no mains power.
Note that a timed relay protection circuit has been incorporated into the MC2.1 to
prevent bangs and other potentially harmful artifacts from occurring during power up
and power down.
SPEAKER CALIBRATION TRIM CONTROLS
On the under-side of the MC2.1 there are seven rotary controls that allow the
individual speaker level calibration of your system. Each speaker output has a
control, including the mono/sub. To alter the speaker level use a small screwdriver
to turn - counter-clockwise turns the speaker level down, and clockwise up.
For the calibration process see the “Monitor Calibration” section of this manual.
Once the system has been calibrated these trims should not be touched.
11
12