Cabletron Systems 9W111-08 - Manual (Page 18)

Installing the MMAC-Plus Module
2-6
An RJ-45 connector provides a COM interface to the management terminal.
Figure 2-4 shows the pinouts.
Figure 2-4. Console Cable Pinouts
Connect the console to the module as follows:
1. Attach the male RJ-45 connector to the COM port of the 9W111-08.
2. Attach the female end (25-pin or 9-pin, as applicable) to the terminal.
Refer to the Cisco Systems documentation for the R4500 router, for information on
configuring this module.
Pin 1
RJ-45 COM PORT
CLEAR TO SEND
2
3
5
7
RECEIVE
TRANSMIT
SIGNAL GROUND
RJ-45 TO 25 PIN
CABLE
FEMALE - 25 Pin
"D" Shell Connector
20 DATA TERMINAL READY
4
1
5
2
6
TRANSMIT
RECEIVE
DATA SET READY
DATA TERMINAL READY
SIGNAL GROUND
COM PORT
RJ-45
LOCAL
MANAGEMENT
CONSOLE
RECEIVE
TRANSMIT
SIGNAL GROUND
RJ-45 TO 9 PIN
CABLE
FEMALE - DB-9
(9-Pin Connector)
3
2
5
8
DATA SET READY
1
4
5
2
6
TRANSMIT
RECEIVE
SIGNAL GROUND
7
DATA TERMINAL READY CLEAR TO SEND
READY TO SEND