Dromida Kodo Manual - Manual

Radio Controlled
Quadcopter
™
Radio
2G Memory Card
USB Card
Reader
Rotor Blade Guards
AAA Batteries (2)
USB Charge
Cord
Spare Blades
(2 black, 2 white)
Flight Battery
KODO Quadcopter
CHARGING THE FLIGHT BATTERY
• NEVER leave the battery unattended while
charging.
• DO NOT allow the USB port to power down
while the charger is connected to the battery.
• ALWAYS unplug the charger from the USB port
and the battery when charging is complete.
Plug the charger into a USB to AC adapter
or USB port on a computer as shown
and connect the battery. The red LED
will flash slowly while charging and be
steady when the charge is complete.
RADIO SETUP
PROP GUARD INSTALLATION
Remove the screw on the
battery compartment cover.
Take the cover off and insert
2 AAA batteries.
1. Carefully pry off the prop
using a screwdriver.
NOTE: Do one corner at a time so you
don’t accidentally mix up the props
2. Push the prop guard in place.
3. Push the prop onto the motor
so it is tight on the shaft.
To protect the propellers from crash damage, attach
the prop guards before flight.
RADIO
For Mode 1 operation, slide the mode
switch to the MD1 position and hold the
controller with the throttle on the right side. For Mode 2 operation, slide the mode
switch to the MD2 position and hold the
controller with the throttle on the left side.