Full duplex configuration screen fields – Cabletron Systems 9E423-36 User Manual
Page 7
5
9E423-36 Module Specific Information
Full Duplex Configuration Screen Fields
The following information briefly explains each Full Duplex Configuration Screen
field.
OPERATION MODE
(Toggle)
Lets you determine whether the specified port will transmit and receive data
separately or simultaneously. You can set this field to one of the following values:
•
STANDARD ENET - The port can either transmit data or receive data, but not
both at the same time. Therefore, the port is running at 10 Mbps (this is the
default).
•
FULL DUPLEX - The port can transmit and receive data at the same time.
Therefore, the port is running at 20 Mbps.
LINK STATUS
(Read-only)
Indicates whether there is a physical connection from this port to another
10Base-T device. One of the following values appears:
•
Link - There is a 10Base-T link signal present; there is a valid physical
connection from this port to another 10Base-T device.
•
No Link - There is no 10Base-T link signal present; there is no valid physical
connection from this port to another 10Base-T device.
PORT STATUS
(Read-only)
Indicates whether the port has been turned on or off administratively. You will see
one of the following values:
•
ENABLED - The port is turned on administratively.
•
DISABLED - The port is turned off administratively.
Enable or disable ports from the Bridge Configuration screen.
NOTE