Dynaflite DYFA3040 - Manual (Page 7)

Die-Cut Pattern
1 REQ. CHPGIPW06
1/16" X 3 - 3 / 8 " X 16" PLY
C H P G W 0 5
Note: If you will be building functional flaps for your
Chipmunk, glue in the lightening holes in ribs W4
and W5.
Note: This page shows the location of the die-cut
parts for the wing. Not all parts are marked on the die
sheets. Be sure to mark all parts with a ball point pen
prior to removing them from the die sheets.
2 REQ,
1/8" X 5 - 3 / 8 " X 2 0 - 5 / 8 " PLY
CHPGW04 2 REQ.
3/32" X 3" X 18" B A L S A
C H P G W 0 3 A 2 REQ.
3 / 3 2 " X 3" X 30" B A L S A
C H P G W 0 3 2 R E Q .
3/32" X 3" X 30" B A L S A
CHPGW02 2 REQ.
3/32" X 3" X 30" B A L S A
CHPGW01 2 REQ.
3/32" X 3" X 30" B A L S A
7