Dynaflite DYFA1009 - Manual (Page 37)

LJ 7. Mount the engine to the firewall.
Q 8. Mount the landing gear in the fuselage with the
mount plate and four #2 x 3/8" screws, then mount a
1-1/2" wheel with a 3/32" wheel collar (not
included, GPMQ4302) on each landing gear wire.
RIGHT WRONG
LJ 3. Position the control horn on the right side of
the rudder so the holes in the control horn align with
the hinge gap.
Q 4. Use the holes in the base of the control horn as
a guide to drill two 1/16" holes through the rudder,
then mount the control horn with two 2-56 x 3/8"
screws and the nylon control horn plate.
d 5. Make a Z-bend in the other pushrod and
connect the elevator servo to the elevator with the
pushrod connector and a control horn the same way
you did the rudder.
Q 6. Cut the wires so they protrude from the pushrod
connector by 3/8".
I—I 9. Use a sharp hobby knife to lightly cut a small
strip of covering from the bottom of the fuselage
where the die-cut 1/16" plywood tail skid is to be
located. In the Covering section of the manual we
discourage the practice of cutting the covering directly
on the balsa, but it is okay to do for the tail skid since
it is not structural. If you haven't already done so,
cover the skid with the same iron-on film you used for
the rest of the model, or just pant it. Use medium CA
to glue the tail skid to the bottom of the fuselage.
FINISH INSTALLING THE RADIO
U 1. Wrap your battery pack in 1 /4" foam rubber,
then mount it in the fuselage in the location shown
on the plan. Be certain the #2 x 3/8" screws that
37