4k fiber optic extenders, 1x lc, Quick start guide – DVIGear DVI-7314 User Manual
Page 3
Installation Instructions
This product consists of a DVI-7313 / DVI-7314 Transmitter Unit and a DVI-7313 / DVI-7314 Receiver
Unit. These units are interconnected by means of a single-channel LC optical cable, utilizing either
50/125μ Multi-Mode fiber or 9/125μ Single-Mode fiber (DVI-7314). The DVI-7314 is also capable of
using Multi-Mode fiber. For maximum cable lengths, please see the chart on page 4.
1.)
Learn the EDID from the destination device (see instructions on page 4).
2.)
Connect the Transmitter Unit to the output port of the signal source (e.g. PC). For a DVI source,
simply connect the Tx to the DVI output. For an HDMI source, use the included DVI female to
HDMI male adapter cable.
3.)
Connect the Receiver Unit to the input port of a destination device (e.g. digital display). For
a DVI destination, simply connect the Rx to the DVI input. For an HDMI destination, use the
included DVI female to HDMI male adapter cable.
4.)
Each unit has one (1) Optical port. Connect an LC-terminated fiber optic cable between the
Transmitter Unit and the Receiver Unit.
5.)
Connect the External AC Power Adapter to the power input jack on the Receiver Unit.
6.)
Apply power to the display device, then apply power to the source device. A picture should appear
on the display within a few seconds.
Power Sources
The Receiver Unit must be powered from the supplied External AC Power Adapter. It cannot be
powered from the connected display device. However, the Transmitter Unit can draw power from the
source device in most applications. In the event that the source cannot provide adequate power for
the transmitter, an optional External AC Power Supply is available (part number DVI-7210-PS).
4K Fiber Optic Extenders, 1x LC
Quick Start Guide
DVI-7313
DVI-7314
3
Note: The DVI-7313 / DVI-7314 Transmitter units and Receiver units use the same type of
enclosure and have the same connections.
1. DVI Connector
DVI-7313-TX / DVI-7314-TX connects to source;
DVI-7313-RX / DVI-7314-RX connects to display
2a. Top LED
Tx: Flashes Blue momentarily when EDID has been read successfully;
Rx: Illuminates Blue when connected to a working display
2b. Bottom (Power) LED
Illuminates Red when DC power is applied
3. Fiber Optic Connector
1x LC optical connector for fiber optic cable
4. DC IN Connector
Connect the External AC Power Adapter to this receptacle
5. Learn EDID Button (TX)
Use a stylus to actuate this switch following the procedure on page 4