Century PM-0624AB - Manual (Page 5)

ENGLISH
4
CAR SEAT/STROLLER USAGE
❃ To Attach Car Seat Adapter:
1 Step down on brake lever to lock
brakes.
2 Release both levers on sides of
seat back.
NOTE: Stroller seat back MUST
be in reclined position to use
car seat adapter.
3 With release handle of car seat
adapter facing away from stroller,
align both sides of adapter bracket
with top of stroller handle grip
buttons.
4 Rotate adapter bracket into
handle grip opening and snap
into place.
Repeat for opposite side.
Pull on adapter to be sure
adapter is locked.
❃ To Attach Car Seat:
1 Step down on brake lever to lock
brakes.
2 With car seat facing stroller handle and
stroller canopy in closed position,
place round car seat handle hubs
into curved slots of car seat
adapter. Both sides must
“click” into position.
❃ To Attach Car Seat continued
3 Push in red button on each handle
hub and rotate handle back until
it “clicks” and locks just behind
car seat.
4 Pull up on both handle hubs to be
sure car seat is locked in car seat
adapters.
NOTE: Car seat comes with a level indicator which is used
for vehicle installation only.
WARNING
Avoid serious injuries from falls. Be sure:
• Harness straps are used to restrain child.
• Car seat handle is in locked carrying position when
lifting or carrying child.
• Car seat is locked into adapter before each use.
• Stroller is fully set up and locked before using.
• Brakes are locked when attaching and removing car
seat from stroller frame.
Red Button
❃ To Remove Car Seat From Stroller:
1 Step down on brake lever
to lock brakes.
2 Push red buttons on car seat
handle and rotate handle up
until it “clicks” into the locked
carrying position (upright).
Do not lift car seat from car seat
adapter until you have checked
that handle is locked.
3 Pull release lever and lift car seat out
of car seat adapter.
Release Lever