ebm-papst EC-motors - Manual

page 1 of 5
Operating manual for
DC- /EC- motors
name: BCI-63.55
item number: 9316355107
The name and the item number as well as the manufacturing date
(calendar week/year of construction) can be found either on the
nameplate or as overprint on the product.
For any further queries please contact:
ebm-papst St. Georgen GmbH & Co. KG
Hermann-Papst-Straße 1
78112 St. Georgen
Germany
telephone: +49 (0) 7724 / 81-0
telefax: +49 (0) 7724 / 81-1309
email: [email protected]
Further information: www.ebmpapst.com
date: 07 December 2011
version : 1.0
content:
IMPORTANT SAFETY INFORMATION 1
TECHNICAL DATA 3
INTENDED USE 3
NOT INTENDED USE 3
CONNECTION AND COMMISSIONING 3
FAULTS, POSSIBLE CAUSES AND REMEDIES 4
CLEANING 4
DO NOT CLEAN THE PRODUCT
USING A WATER JET OR PRESSURE WASHER. 4
DO NOT USE CLEANING AGENTS
THAT CONTAIN ACIDS, CAUSTIC SOLUTIONS OR
SOLVENTS.
4
DO NOT CLEAN THE PRODUCT
USING POINTED OR SHARP OBJECTS. 4
MAINTENANCE 4
IMPORTANT SAFETY INFORMATION
This manual has to be supplied to the staff before working on or with
the product, before every installation and operation, before
maintenance or overhauls and any other use. Keep this manual for any
later use and for following owners.
By all means read this manual carefully before working on or with the
product. Pay attention to the following information and warnings to
avoid risk of persons or objects and act accordingly.
In the event of resale or transfer of the product the manual must
accompany the product. This manual may be copied and provided as
information on potential risks and their avoidance.
Hazard classification of warning notices
The following risk ratings are used in this manual to denote potential
risk situations and important safety instructions:
DANGER
This is a potentially dangerous situation
and warns of an impending health risk or
risk of fatal injury if this warning is not
observed. Observe this warning by all
means.
WARNING
The dangerous situation can occur and
result in major or fatal injuries if the
warning is not observed. Work with
extreme care.
CAUTION
The dangerous situation can occur and
result in minor injuries or damage to
property if the warning is not observed.
NOTE
A potentially dangerous situation can
occur and result in damage to property if
not avoided.
Qualification of personnel
Only instructed and authorized skilled personnel is permitted to
transport, unpack, operate and service the product.
Only skilled electricians are permitted to install the product, carry out
the test run and work on the electrical unit.
.
Basic safety regulations
Safety risks related to the product must be reassessed after installation
into the final device.
The operating manual was developed in accordance with European
market requirements and may need adapting to the market
requirements of the country in question.