Cisco CISCO UNIFIED OL-18988-01 - Manual (Page 8)

3-8
Cisco Unified IP Phone 7931G Administration Guide for Cisco Unified Communications Manager 7.1 (SCCP and SIP)
OL-18988-01
Chapter 3 Setting Up the Cisco Unified IP Phone
Verifying the Phone Startup Process
To mount the phone on the wall without using the wall mount kit, follow these steps:
Caution Use care not to damage wires or pipes located inside the wall when securing screws to wall studs.
Procedure
Step 1 Remove the footstand if it is attached to the phone.
To remove the footstand, disengage its tabs from the phone by grasping and gently squeeze it at the top
and bottom near where it attaches to the phone.
Step 2 Insert two screws into a wall stud, matching them to the two screw holes on the back of the phone.
The holes fit standard phone jack mounts.
Step 3 Hang the phone on the wall.
Verifying the Phone Startup Process
After the Cisco Unified IP Phone has power connected to it, the phone begins its startup process by
cycling through these steps.
1. These buttons flash on and off in sequence:
– Mute.
– Speaker.
– Line 1 (amber)
2. The phone screen displays the Cisco Systems, Inc., logo screen.
3. These messages display as the phone starts:
– Verifying load (if the phone load does not match the load on the TFTP server). If this message
displays, the phone start up again and repeats step 1 and 2 above. The phone also displays the
download progress and names of files it downloads and upgrades.
– Configuring IP.
– Updating CTL.
– Updating Locale.
– Configuring CM Unified List.
– Registering.
4. The main phone screen displays:
– Current date and time
– Primary directory number
– Additional directory numbers and speed dial numbers, if configured
– Softkeys
If the phone successfully passes through these stages, it has started up properly. If the phone does not
start up properly, see the
“Resolving Startup Problems” section on page 9-1 .