Cisco CISCO UNIFIED OL-18988-01 - Manual (Page 5)

3-5
Cisco Unified IP Phone 7931G Administration Guide for Cisco Unified Communications Manager 7.1 (SCCP and SIP)
OL-18988-01
Chapter 3 Setting Up the Cisco Unified IP Phone
Installing the Cisco Unified IP Phone
Installing the Cisco Unified IP Phone
You must connect the Cisco Unified IP Phone to the network and to a power source before using it. See
Figure 3-1 for a graphical representation of the connections.
Perform the steps shown in Table 3-1 to install a Cisco Unified IP Phone.
Table 3-1 Installing the Cisco Unified IP Phone
Installation Step
Notes Reference
Step 1 Connect the handset to
the Handset port. — —
Step 2 Connect a headset to
the Headset port. Optional. You can add a headset later if
you do not connect one now. See the “Headset” section
on page 3-3 for supported
headsets.
Step 3 Connect the power
supply to the Cisco DC
Adapter port. Optional. See the “Providing Power
to the Phone” section on
page 2-3
.
Step 4 Connect a Category 3
or 5 straight-through
Ethernet cable from
the switch to the
10/100 SW port. Each Cisco Unified IP Phone ships
with one Ethernet cable in the box. See the “Network and
Access Ports” section on
page 3-2
for guidelines.
Step 5 Connect a Category 3
or 5 straight-through
Ethernet cable from
another network
device, such as a
desktop computer, to
the 10/100 PC port. Optional. You can connect another
network device later if you do not
connect one now. See the “Network and
Access Ports” section on
page 3-2
for guidelines.