8 bit movement, Dip switches (settings explained), Witches – Chauvet Legend 6000X User Manual
Page 16: Settings explained
Appendix
C
HANNEL
V
ALUE
F
UNCTION
8
000
Щ 063
064
Щ 127
128
Щ 143
144
Щ 255
Beam Effect
Full Beam
Frost Filter
Flat and wide beam effect at 0°
Flat and wide beam effect 90° adjustment
9
000
Ù 255
Zoom
10° > 30°
10
000
Ù 255
Pan
0° > 570° ( 128 = center)
11
000
Ù 255
Tilt
0° > 270° (128 = center)
12
000
Ù 255
Pan (Fine)
13
000
Ù 255
Tilt (Fine)
14
000
Щ 007
008
Щ 063
064
Щ 127
128
Щ 191
192
Щ 255
Control
Utilizes an internal ramp to provide smooth Pan/Tilt
movement and adjustment
Disables the internal ramp to provide faster Pan/Tilt
movement and adjustment
Color calibration
Pan: Color Wheel
Tilt: Cyan
Pan (Fine): Magenta
Tilt (Fine): Yellow
( See Appendix, Color Calibration)
Save calibration settings after 3 seconds
Reset all motors after 3 seconds (does not reset calibration)
15
000
Щ 047
048
Щ 095
096
Щ 159
160
Щ 207
208
Щ 255
Lamp ON/OFF
Standby
Hold 3 seconds for Lamp ON
Standby
Hold 3 seconds for Lamp OFF
Standby
8 Bit Movement
In the 8 bit Pan/Tilt resolution setting both (FINE) channels is removed. All other channel parameters
remain the same as in the “DMX Channel Values” table.
C
HANNEL
F
UNCTION
C
HANNEL
F
UNCTION
C
HANNEL
F
UNCTION
1
Dimmer 6
Yellow 11
Tilt
2
Shutter/Strobe
7
Color Macro
12
Control
3
Color Wheel
8
Beam 13
Lamp ON/OFF
4
Cyan 9
Zoom
5
Magenta 10
Pan
Dip Switches (settings explained)
D
IP
S
WITCH
E
VENT
N
OTES
All Off
The lamp will strike first. If striking of the lamp succeeds, in approximately
15 seconds the fixture’s motors will be powered and initialized. If the lamp
does not strike, the remainder of the fixture will not initialize and you will
not have control of the fixture. Please wait 15 minutes before re-
starting the fixture, otherwise perform a service check.
This is the default setting on the fixture and
helps in reducing the amount of striking or
inrush current used by the fixture upon startup.
1-On
Lamp and motors are powered at the same time.
Will consume the most amount of inrush current
in the startup phase.
2-On
1-On, 2-On
Only the lamp will turn on in the fixture
3-On
This switch will terminate the dmx connection.
Use only at the end of a DMX daisy chain.
LEG-6000 User Manual
16
Revision: 2007-03-06/09:06