Chauvet Legend 6000X - Manual (Page 7)

Power
Your product is equipped with an internal input-voltage select switch.
Warning! Verify that the power select switch on your unit matches the line voltage applied. All
fixtures must be connected to circuits with a suitable Earth Ground.
Remove the right base
cover panel as
illustrated here to gain
access to the switch
shown below.
Input Voltage Switch
2
3
3,4,5
• To determine the power requirements for
a particular fixture, see the label affixed to
the back plate of the fixture or refer to the
fixture’s specifications chart.
• A fixture’s listed current rating is its
average current draw under normal
conditions.
• All fixtures must be powered directly off a
switched circuit and cannot be run off a rheostat (variable
resistor) or dimmer circuit, even if the rheostat or dimmer
channel is used solely for a 0% to 100% switch.
• Before applying power to a fixture, check that the
source voltage matches the fixture’s
requirement.
• All fixtures must be connected to circuits
with a suitable Earth Ground.
1. Make sure the fixture is not connected to power, if
so disconnect.
2. Remove the right base access cover panel as
illustrated on the right.
3. Locate the power selection switches and dial.
4. Rotate the voltage dial to the setting that most closely matches the local AC voltage. If your
voltage falls halfway between two settings, select the higher voltage on the dial.
5. Move the frequency switch to the setting that matches the local AC frequency; 50 or 60 Hz.
6. Replace access cover.
P ow e r C a b l e C o n f i g u r a t i o n
C ABLE P IN I NTERNATIONAL
B ROWN Live L
B LUE Neutral N
Y ELLOW /G REEN Earth EG (Ground)
LEG-6000 User Manual 7 Revision: 2007-03-06/09:06