Ecler CA series - Manual (Page 2)

CA series presets save and recall
page 2 / 4
And these are the general device parameters, which are not preset‐dependant (they
are not stored in a preset when it is saved, thus they’re not modified with a preset
recall):
 AMPLIFIER working mode: STEREO, MONO, BRIDGE, ZONES (
CA40: configured
by hardware dip switches )
 Auto‐Standby function ON/OFF status (
CA40: configured by hardware dip
switches )
 REMOTE port ON/OFF status (
CA40: configured by hardware dip switches )
 REMOTE port inputs/presets selection mode
 Preset #1 automatic recovery at start up
 Infrared receiver enable/disable status (
CA40: not applicable )
 LCD mode when idle: ON, OFF, DIMMED (
CA40: not applicable )
 LCD contrast value (
CA40: not applicable )
 ZONE LABEL (
CA40: not applicable )