Ecler PRS10T - Manual (Page 5)

5
4. CONNECTIONS
In order to always obtain optimal output use the appropriate voltage and power.
100V line power selection is performed by the connection wiring according to the following
colour code:
RED – BLUE = 10W
YELLOW – BLUE = 5W
GREEN – BLUE = 2.5W
If the projector is used in 70.7V facilities the power indicated in the table for 100V line will
be reduced to half, and to a quarter for 50V facilities.
Once the right power is selected for the application and line voltage, the projector is ready
to be used.
5. LOCATION AND ASSEMBLY
Unit installation should be performed with fastenings designed for the type of supporting
material. To change projector position, lightly unscrew the U-shaped bracket in order to obtain the
final position you want; keep in mind the area you want to reach to set the projector correct vertical
angle.
Re-tighten the mounting screws to secure the projector in its final position.