Ecler MPAGE4 User Manual
Page 6
6
2.
Activation of the carillon melody (optional). With the two CHIME (6) micro-switches on
the rear panel of the MPAGE4 it is possible to: deselect the carillon melody (both set
to OFF) or select one of three carillon melodies combining the ON and OFF positions
(ON-OFF, OFF-ON and ON-ON). ON position = micro switch down.
3.
Level adjustment: the two adjustment potentiometers are accessed by removing the
lid from the unit:
x
MIC (9): adjusts the microphone signal gain
x
CHIME (8): adjusts the level of the carillon melody signal (0-100%)
The console (5) microphone is a non-extractable electret cardioid type mounted on a
flexo. It is supplied with an "anti-pop" foam windshield.
The audio output is balanced and is sent through pins 1, 2 and 3 of the RJ-45 connector
on the rear panel of the unit for reception by the MIMO54.
4. OPERATION
Once the MPAGE4 unit is connected to the MIMO54, the procedure for sending messages
is as follows:
1.
Selection of receiving zones by pressing:
x
keys ZONE 1 to ZONE 4 (3) as desired (if LED indicators are lit it means
that the zone is selected)
x
or the ALL (4) key to select all 4 zones simultaneously (if the LED indicator
is lit it means that ALL zones are selected)
All of the keys are mechanically interlocked (activated by pressing once
and deactivated by pressing again)
2. Hold the PAGE (1) key down ( “push to talk” type key without mechanical
interlocking) while the voice message plays through the built-in goose-step
microphone. The LED (2) on the key is lit while the key is pressed down (active
message)
Note: if the carillon melody was activated, we recommend waiting a short period of
time (3-4 seconds) after pressing the PAGE key and before starting the voice
message in order to prevent the message from overlapping with the melody
3.
If necessary, cancel the individual zone selection (ZONE 1 to 4) or the selection of all
zones (ALL) by pressing the keys again, verifying that the LEDs go out. If the
selection is not cancelled, the next message that is sent will be delivered to the
selected zones.
It is also possible to select zones permanently using the MIMO54. This is done by
placing the required zone or zones to the ON position using the ZONE switch on the front panel of
the MIMO54. These permanently selected zones will always receive the messages sent from the
MPAGE4 unit regardless of whether or not they have been selected using the push buttons.