Chauvet 160-LED - Manual (Page 17)

Operation
Q-Spot™ 160-LED User Manual Rev. 01b -13-
Menu Map
1 st Level 2 nd Level 3 rd Level Description
1-Intro
Address 001~512 Sets the DMX starting address
Reset Yes/No Resets the fixture to the “home” position
Run
DMX-512 Sets the fixture to DMX mode
Auto 1 Starts the hanging auto mode (pointing down)
Auto 2 Starts the floor standing auto mode (for placing on speaker)
Sound 1 Starts the hanging sound mode (pointing down)
Sound 2 Starts the floor standing sound mode (for placing on speaker)
Custom Runs the user’s program
Test Runs a standard test program
Slave The fixture responds to a master unit
Channels
Advanced 16-bit pan/tilt operation
Basic 8-bit pan/tilt operation
Display
60 close Turns the display backlight off after 60 seconds of being idle
Bright Sets the display backlight to remain on indefinitely
Info Edition Shows the software version
2-Invert
Pan
Normal Sets the Pan operation: 0~540º
Reverse Reverses the Pan operation: 540~0º
Tilt
Normal Sets the Pan operation: 0~270º
Reverse Reverses the Pan operation: 270~0º
Color
Step Sets the color wheel channel to locking colors
Linear Allows split color operation on the color wheel channel
Use No/Yes Enables / disables all Invert functions
3-Range
P/start 000~255 Sets the Pan starting range
P/Finish 000~255 Sets the Pan end range
T/start 000~255 Sets the Tilt starting range
T/Finish 000~255 Sets the Tilt end range
Use No/Yes Enables / disables all Range functions
4-Special
Black
No Move-in-black is active only when Control channel = 020~039
Yes
Move-in-black activates permanently if Control channel = 020~039
for 3 seconds. (requires Control channel = 040~059 to deactivate it)
Reset
DMX Allows the reception of a DMX remote reset command
System Disables the reception of a DMX remote reset command
5-Edit
Step 000~255 Selects which step to edit
Pan
000~255
Use the nine different attributes of the fixture to create a custom step
(repeat for the other steps)
Tilt
X/Y_Speed
Color
Gobo
Gobo_Rot
Prism
Dimmer
Strobe
Time 000~255 Selects the duration of the step
Use No/Yes Enables / disables the program step
6-Default Default No/Yes Defaults the fixture and erases the custom programs