EDCO SS-16A - Manual (Page 12)

E-SS20/16A-I-0607
Printed in USA
©2007
TVW
Page 12
100 Thomas Johnson Drive, Frederick, MD 21702-4600 USA
Phone (301) 663-1600 • 1-800-638-3326
Fax (301) 663-1607 • 1-800-447-3326
Website: www.edcoinc.com
Email: [email protected]
®
A Division of Equipment Development Company, Inc.
Check Engine Oil Before Each Operation -
Check Engine Manufacturer’s Owner’s Manual for specific
instructions.
Change Oil & Filter Every 50 Hours of Operation
(Sooner if Necessary).
Check Drive Chains Before Operation -
Lubricate Weekly
Open gas tank door -
Drive chain is just inside, on the right.
Inspect/adjust Arbor Drive and
Drive Belts -
On new machines and
after installation of new belts,
adjust belt tension after the first four hours,
then as necessary.
Loosen engine mount bolts (2)
turn jacking bolt to lift engine mount. (1)
Note:
To change the drive belt, the engine must be
slid forward. Loosen the engine bolts (4)
that hold the engine to the mount and slide
the engine forward to its original position.
Retighten the engine bolts and follow the
directions above to retighten the arbor belts.
Drive Chain
Belts
Front
Engine
Mount
Bolts (2)
Remove
Belt Guard
Jacking
Bolt
Arbor
Belts
Drive
Belt Engine
Bolts (4)