EDCO BB14E - Manual (Page 14)

Page 14
E-BB14E&BB14G-I-0714
800-638-3326 • edcoinc.com • [email protected]
EQUIPMENT DEVELOPMENT CO., INC.
Clean and Lubricate Wheels on Rolling Table:
• During daily visual inspection, check to be sure the wheels on
both sides of the rolling table move smoothly and that there is no
debris in the wheel groove. (Circled) (Figure 26)
• Lubricate the wheels as necessary.
• Replace damaged or worn wheels.
Inspect and Clean Air Filter:
(FIgure 25 shows Honda Cyclone Dual Filter style element).
• Refer to the Engine Manufacturer’s Owner’s Manual for instructions
on specifi c models.
• Check air fi lter at least once daily.
• Dirt build up on the fi lter will cause excessive engine wear.
Change Engine Oil:
• Check Engine Oil before each operation. Open the fi ller cap and
look at the dip stick. (Figure 24) Oil should be clearly visable both
on the stick and in the cavity and should look fairly clean. Running
the machine on dirty oil or when the oil is low will result in damage
to the engine.
• Change the Engine Oil after every 50 hours of operation or sooner
as conditions require. Refer to the Engine Manufacturer’s Owner’s
Manual for specifi c viscosity recommendations and changing
instructions.
Grease Bearings:
• Drive shaft bearings must be greased every 4 hours.
(All are not visible in this photo)
• Electric Motor - if your motor has a grease fi tting, grease every
3600 hours. Use Exxon Mobil Polyrex EM. Don not over grease.
Apply 1 pump slowly taking a minute to apply. Too much grease
can cause premature bearing failure.
Figure 26
Figure 23
Figure 25
Figure 24
Dip Stick
Grease Fittings