EDCO GMS-10 - Manual (Page 2)

Printed in USA
© 2000
Page 2
E-GMS10-I-03/00
100 Thomas Johnson Drive, Frederick, MD 21702-4600 USA
Phone (301) 663-1600 • 1-800-638-3326
Fax (301) 663-1607 • 1-800-447-3326
Website: www.edcoinc.com • Email: [email protected]
Read and understand these instructions thoroughly before
attempting to operate this equipment.. Different models have
different parts and controls, death or serious injury could
occur if the machine is used improperly.
• Equipment should only be operated by trained personnel in good
physical condition and mental health (not fatigued). The operator
and maintenance personnel must be physically able to handle the
bulk weight and power of this equipment.
• This is a one person tool. Maintain a safe operating distance to
other personnel. It is the operators’ responsibility to keep other
people (workers, pedestrians, bystanders, etc.) away during opera-
tion. Block off the work area in all directions with roping, safety
netting, etc. for a safe distance. Failure to do so may result in others
being injured by flying debris or exposing them to harmful dust and
noise.
• This equipment is intended for commercial use.
• For the operators safety and the safety of others, always keep all
guards in place during operation.
• Never let equipment run unattended.
• Personal Protection Equipment and proper safety attire must be
worn when operating this machinery. The operator must wear ap-
proved safety equipment appropriate for the job such as hard hat
and safety shoes when conditions require. Hearing protection MUST
be used (operational noise levels of this equipment may exceed
90db) . Eye protection MUST be worn at all times. A dust/particle
respirator must be used when cutting or grinding without an ad-
equate dust control system in place.
Keep body parts and loose clothing away from moving parts.
Failure to do so could result in dismemberment or death.
• Do not modify the machine. Use only genuine EDCO parts and
accessories. Repairs and service should be performed by EDCO or
by approved EDCO dealers or repair technicians.
• Stop motor/engine when adjusting or servicing this equipment.
Maintain a safe operating distance from flammable
materials. Sparks from the cutting-action of this machine can
ignite flammable materials or vapors.
• Always keep all guards in place during operation for the operators’
safety and the safety of others.
READ AND UNDERSTAND THE OPERATORS INSTRUCTION MANUAL THOROUGHLY
BEFORE ATTEMPTING TO OPERATE THIS EQUIPMENT.
Death or serious injury could occur if this machine is used improperly.
Engine exhaust from this product contains
chemicals known to the State of California to cause
cancer, birth defects or other reproductive harm.
• This equipment will create dust from the material being removed.
That dust may contain chemicals known to the State of California to
cause cancer and/or birth defects or other reproductive harm. Check
the chemical properties of the material to be removed and take the
appropriate precautions.
• Extreme care must be taken when operating electric
models with water present: Ensure power cord is properly
grounded, is attached to a Ground-Fault-Interrupter (GFI)
outlet, and is undamaged.
• Check all electrical cables - be sure connections are tight and
cable is continuous and in good condition. Be sure cable is cor-
rectly rated for both the operating current and voltage of this equip-
ment.
Improper connection of the equipment-grounding
conductor can result in a risk of electric shock. Check
with qualified electrician or service person if there is
any doubt as to whether the outlet is properly
grounded. Adhere to all local codes and ordinances.
• NOTE: In the event of a malfunction or breakdown, grounding pro-
vides a path of least resistance for the electric current to dissipate.
The motor is equipped with a grounded plug and must be connected
to an outlet that is properly installed and properly grounded. DO
NOT modify the plug provided on the motor. If the plug does not fit
the outlet have a qualified electrician install the proper receptacle.
• Switch motor OFF before disconnecting power.
• Do not disconnect power by pulling cord. To disconnect, grasp the
plug, not the cord.
• Unplug power cord at the machine when not in use and before
servicing.
Engine exhaust from this product contains chemicals known
in certain quantities, to cause cancer, birth defects or other
reproductive harm.
• Gasoline is extremely flammable and poisonous. It should only be
dispensed in well ventilated areas, and with a cool engine.
Do not operate gasoline powered equipment with-
out adequate ventilation. Carbon monoxide is an
invisible, odorless gas that can kill.
SAFETY
MESSAGES
EXHAUST HAZARD
GENERAL INSTRUCTIONS SAFETY MESSAGES
GASOLINE POWERED EQUIPMENT
ELECTRICAL POWERED EQUIPMENT
• Safety Instructions are proceeded by a graphic alert
symbol of DANGER, WARNING, or CAUTION.
Indicates an imminent hazard which, if not avoided,
will result in death or serious injury.
Indicates an imminent hazard which, if not avoided,
can result in death or serious injury.
Indicates hazards which, if not avoided, could result
in serious injury and or damage to the equipment.