Eliminator Lighting Mirage LED - Manual

Mirage LED SPECIFICATIONS:
Model: Mirage LED
Supply Voltage: 100~240V 50/60Hz
LEDs: 8 LEDs - 2 Red, 2 Green,
2 Blue, & 2 White
Weight: 10.5lbs./ 4.8kgs.
Size: 22.8” (L) x 5.8” (W) x
4.5” (H)
Fuse: 6.3 Amp
Power Cord Daisy Chain: 9 Fixtures Max.
Working Position: Any Safe position
Duty Cycle: None
DMX Channels: 6 DMX Channels
Colors: RGBW
Warranty: 1 Year
CAUTION! Please read and
understand these instructions
before installing or operating
this unit.
Operating Instructions:
The Mirage LED has been tested at the factory, there is no assembly required. The unit is ready to
be plugged into a power outlet. This unit is a 6 channel DMX intelligent LED par can. The Mirage
LED has three operating modes; Sound Active mode, Show mode, or as a DMX controlled unit. The
unit can run as a stand alone fixture or in a Master/Slave configuration.
Power Cord Daisy Chaining: With this feature you can connect the fixtures to one another using the
IEC input and output sockets. The quantity that can be connected is 9 fixtures maximum. After 9 fix-
tures you will need to use a new power outlet. They must be the same fixtures. DO NOT mix fixtures.
©Eliminator® Los Angeles, CA. - www.EliminatorLighting.com
Caution! Never open unit when in use.
Always disconnect main power before
replacing fuse. Remember to always
replace with the exact same type fuse.