Eliminator Lighting Gyro LED - Manual

GYRO LED
©Eliminator® Los Angeles, CA. - www.EliminatorLighting.com
I ntroduction:
The Gyro LED is a 7 channel DMX intelligent scanner unit. The Gyro LED has 3 operating modes; sound
active mode, auto program mode, or it can be controlled by a DMX controller. The unit can be run as a stand
alone unit or in a Master/Slave configuration. This unit has been tested at the factory, there is no assembly
required. The unit is ready to be plugged in to a power outlet. To enhance the beams effects you can use a
fog machine. This unit looks good in pairs.
CAUTION! Please read and understand these instructions before installing or operating this unit.
SPECIFICATIONS:
Model: Gyro LED
LED: 1 x 25W LED
Weight: 9.4lbs./ 4.3kgs.
Size: 12.75” (H) x 6” (W) x
5” (L)
Fuse: 2 Amp
Power Consumption: 50W
Supply Voltage: 110V-240V 50/60Hz
Working Position: Any Safe position
Duty Cycle: None
DMX Channels: 7 DMX Channels
Gobos: 11 plus Spot
Colors: 8 Colors + White
Warranty: 1 Year
CAUTION! Please read and
understand these instructions
before installing or operating
this unit.
Fuse Replacement: Locate and remove
the unit’s power cord. Once the cord has
been removed located the fuse holder
located inside the power socket. Insert
a flat-head screw driver into the power
socket and gently pry out the fuse holder.
Remove the bad fuse and replace with a
new one. The fuse holder has a built-in
socket for a spare fuse be sure not to
confuse the spare fuse with active fuse.