Eliminator Lighting Flash 192 - Manual

Flash 192
SPECIFICATIONS:
Model: Flash 192
Voltage: 100V-230V 50/60Hz
LEDs: 192 x 0.06W
Beam Angle: 60 Degrees
Power Consumption: 15W
Weight: 3.59lbs./ 1.63kgs.
Size: 11”(L) x 7.87”(W) x
2.36”(H) (w/o Bracket)
11”(L) x 7.87”(W) x
7.87”(H) (w/ Bracket)
Fuse: 1 Amp
Power Cord Daisy Chain: 25 Fixtures Max.
Working Position: Any Safe position
Duty Cycle: None
DMX Channels: 4 DMX Channels
Colors: White
Warranty: 1 Year
CAUTION! Please read and under-
stand these instructions before
installing or operating this unit.
Operating Instructions:
The Flash 192 has been tested at the factory, there is no assembly required. The unit is ready to be
plugged into a power outlet. This unit is a 4 channel DMX intelligent strobe. It has 3 operating mode;
Manual mode, Sound Active, or DMX mode. The Flash 192 can be used as a stand alone unit or in a
master-slave configuration.
Fuse Replacement: Disconnect the unit from its power source. Remove the power cord from the
unit. Once the cord has been removed, you will find that the fuse holder is located inside the power
socket. Insert a flat-head screw driver into the power socket and gently pry out the fuse holder.
Remove the bad fuse and replace with a new one. The fuse holder also has a holder for a spare fuse.
Power Cord Daisy Chaining: With this feature you can connect the fixtures to one another using the
IEC input and output sockets. The quantity that can be connected is 25 fixtures maximum. After 25
fixtures you will need to use a new power outlet. They must be the same fixtures. DO NOT mix fixtures.
©Eliminator® Los Angeles, CA. - www.EliminatorLighting.com
Caution! Never open unit when in use. Always
disconnect main power before replacing fuse.
Remember to always replace with the exact same
type fuse.