Eliminator Lighting Crystal Ray LED - Manual

Crystal Ray
LED
SPECIFICATIONS:
Model: Crystal Ray LED
LEDs: (28 Red, 28 Green, 28
Blue, & 28 White)
Weight: 4.6lbs./ 2.1kgs.
Size: 18” (L) x 13” (W) x
8.5” (H)
Fuse: 1 Amp
Supply Voltage: 100V-240V 50/60Hz
Working Position: Any Safe position
Duty Cycle: None
DMX Channels: 4
Colors: RGBW
Warranty: 1 Year
CAUTION! Please read and
understand these instructions
before installing or operating
this unit.
Operating Instructions:
The Crystal Ray LED has been tested at the factory, there is no assembly required. The unit is ready
to be plugged into a power outlet. This unit is a 4 channel DMX intelligent LED sweeping fixture. It
can be run as a stand-alone unit, DMX controlled unit, or in a Master/Slave configuration. While in
Stand Alone or a Master/Slave configuration, the auto mode and sound active mode will run togeth-
er. The fixture will enter Auto Mode when sound is not present. For stand-alone mode, Master/Slave
configuration, and DMX Control see other side.
©Eliminator® Los Angeles, CA. - www.EliminatorLighting.com
Caution! Never open unit when in use.
Always disconnect main power before
replacing fuse. Remember to always
replace with the exact same type fuse.
1 Year Limited Warranty:
Eliminator Lighting warranty is valid from the date of purchase. Our
1 year limited warranty covers manufacturing defects only. Serial number, place of purchase with
dated valid receipt must be submitted at time of service. Eliminator Lighting warranty does not cover
items or parts prone to wear and tear: LEDs, fuses, brushes and belts. Eliminator Lighting warranty
is only valid with-in the United States.