Eliminator Lighting ED-15 - Manual (Page 7)

Operation Guide
4. Audio Mode (dip-switch9=OFF & dip-switch10=OFF)
6
As the above illustration shows, dip-switch9 and dip-switch10 are switched to
the "off" position in Audio mode. Chasing speed is controlled by the bass music
effect, Dip-switches4-7 are used to select the Program, Dip-switch8 is used to
select the Single programming or Loop programming (16 programs in a loop).
3. Auto Mode (dip-switch9=ON & dip-switch10=OFF)
As the above illustration shows, in Auto mode, dip-switch9 is "on", and dip-
switch10 is "off". Dip-switches1-3 are used to select the Speed level, Dip-
switches4-7 are used to select the Program, Dip-switch8 is used to select
Single programming or Loop programming (16 programs in a loop).
5. Notice Information
(1) (2) (3) (4) (5) (6) (7) (8) (9) (10) Dipswitch#
Value
1
8
Program
Single( )
or
Loop( )
On
Off
2
4
Push dip-switch9 and dip-switch10 to the "OFF" position to make the unit into
Audio mode.
When in link, only one ED15 unit can work in the Auto mode or Audio mode,
the other connected units in link must be operated in the Slave mode.
Other types of DMX receiver should not be connected into the linked ED15
units, or something wrong will occur to the connected DMX receiver.
When each linked ED15 unit has received the linking signal or the DMX signal,
the corresponding LED-indicator will blink in time. When the signal go out, the
corresponding LED-indicator will go out subsequently.
This unit has been designed to be hung. It is recommended that, for safety
purpose, the unit should be properly mounted using a suitable hanging clamp
and safety cable.
The printings on the front panel of the unit give user important information for
reference.