Emerson Radio CF353 - Manual (Page 5)

4
LOCATION OF CONTROLS (CONTINUED)
Before Using Your Freezer
• Remove the exterior and interior packing
• Check to be sure you have all of the following parts:
- 1 Storage Basket
- 1 Ice Scraper
- 1 Instruction Manual
• Before connecting the freezer to the power source, let it stand upright for approximately 2
hours. This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
Installing Your Freezer
• This appliance is designed to be free standing only, and should not be recessed or built-in.
• Place your freezer on a floor that is strong enough to support the freezer when it is fully loaded.
• Allow 15 cm of space between the back and sides of the freezer, which allows the proper air
circulation.
• Locate the freezer away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and heat sources may increase electrical consump-
tion. Extreme cold ambient temperatures may also cause the freezer not to perform properly.
• Avoid locating the freezer in moist areas.
• Plug the freezer into an exclusive, properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an
authorized service center.
• After plugging the appliance into a wall outlet, allow the unit to cool down for 2~3 hours before
placing food in the freezer compartment.
1
2
3
1 3 2
3.5 CUBIC FT. CHEST FREEZER
OWNER’S MANUAL
CF353
Visit our Web site at www.emersonradio.com
UNAUTHORIZED MODIFICATIONS TO THIS DEVICE COULD VOID MANUFACTURER’S WARRANTY.