Emerson Radio AV400 Quick Start - Manual (Page 3)

or
or
or
POSITIONING THE SPEAKERS
Refer to the following speaker positioning diagram. All 5 satellites should be approximately the same distance from your listening
position.
• Place center speaker either directly above or below your TV screen.
• Place front left and right speakers to the left and right of TV at approximately the same height as the center speaker.
• Place rear left and right speakers either in line with, or behind your listening position, at ear level, or slightly above, when seated.
• Place subwoofer on the floor in front of the room, either next to TV or in the corner, facing your listening position.
DVD PLAYBACK
1.) Turn on your TV. If necessary press the Source or Video button on your TV’s front panel or TV remote control to select the
external source connected to your TV’s Video In jack. (If necessary refer to your TV’s instruction manual.)
2.) Press the (Standby ‘On/Off’) button on the AV400 remote control to turn the system ‘On’. The Standby indicator goes ‘Off’.
If necessary press the FUNC. button repeatedly on the front panel or the DVD button on the AV400 remote control to select the
DVD function. The AV400 front panel display will show “READING”, and the DVD logo screen should appear on your TV.
3.) Press the (Open/Close) button on the remote control or front panel to open the Disc Tray..
Note: Remote must be pointed at the front of the player to operate properly.
4.) Insert DVD movie disc in tray with printed side facing up. Press (Open/Close) button to close the disc tray. Player will read
the disc and display shows “READING”. On some discs playback will start automatically. On other discs the DVD Menu
Screen will appear. Press PLAY button to begin playback, or use the Cursor buttons (3/4/5/6) and then the OK
button to select other playback options from the DVD menu.
5.) When you play A DVD movie disc, the player will automatically select DOLBY DIGITAL audio mode. If the DVD disc is
recorded with Dolby Digital soundtrack you will hear sound from all 5 satellites plus subwoofer.
6.) Rotate the VOL (Volume) control of the player or press the VOL + / – buttons of the remote control to adjust volume level as
desired.
7.) When finished watching, press the Stop button and/or the (Open/Close) button. Remove the disc, then press the
(Standby ‘On/Off’) button on the remote control to turn the player ‘Off’. The Standby indicator comes ‘On’ again.
Note: Speaker pedestals are for illustration only. Pedestals are not included.