Emerson Radio MS3108 - Manual (Page 17)

16
OPERATING INSTRUCTIONS
• Make sure that you have fully extended the FM antenna wire.
• Make sure that you have installed 2 “AAA” batteries in the remote
control.
• Make sure that the system is connected to an AC outlet that is always
“live”. Do not connect the system to an AC outlet controlled by a wall
switch.
Remove The Dummy CD Transit Protection Cards
This system was shipped with a “dummy CD” transit protection card in each of the
3 CD players. These cards were inserted to prevent the CD player mechanisms
from moving during shipping and handling. They must be removed and discarded
before you can load your own CDs. After connecting the system to your AC outlet,
press the STANDBY (POWER) button to turn the system ‘On’. Then press the
OPEN/CLOSE button to open the CD door. Remove the 3 “dummy CDs” and
discard them.
Press the OPEN/CLOSE button to close the CD door.
General Controls
Most of the main functions of this system can be operated by the controls on the
front panel of the main unit, or by the buttons on the remote control handset. If a
specific function can only be operated by the remote handset, or by the front panel
controls, this will be clearly indicated in the instructions.
When operating this system with the remote control handset make sure that the
Infrared transmitter on the front of the remote handset is pointed at the remote
sensor on the front panel of the main unit. The effective operating range of the
remote control is approximately 15 feet. Please note that bright sunlight or room
lighting may interfere with the remote control operation. If the remote is not operating
properly try reducing the brightness of the room or moving closer to the main unit.
If this does not solve the problem, it may be time to change the remote control
batteries.
MS3108_062806.p65 28/6/2006, 16:54 16