Empress Effects Superdelay - Manual (Page 18)

17
Recalling a Preset
To recall a preset simply press the presets switch until the preset you’d like
to recall is flashing, then press the tap switch to load the preset. The
preset’s LED indicators should now be solid and bright.
Changing a Preset
If you change the position of a knob or switch after a preset is loaded, the
preset’s LED indicators will dim to indicate that the preset has been
modified, but not saved. If you move the knob or switch back to the position
it was in when the preset was saved, the preset’s LED indicators will
brighten again. This lets you find the positions of all the knobs and switches
when the preset was saved.
Once you have made your changes to the preset, you can save it in the
current location by holding the save switch and then pressing the presets
switch. The preset indicator LEDs should brighten to indicate the changes
have been successfully saved.
Factory Reset Presets
To restore the Superdelay to its factory preset settings, do the following:
1. Unplug the power and plug back in.
2. When all the lights come on, press the tap switch.
3. Quickly hold down the save button and press the presets switch.
4. The lights should do a little jig confirming success.
WARNING! This will overwrite your current presets and replace them with
the factory presets.