Envion HH200 - Manual (Page 5)

5 6
USING ThE hUMIdIhEAT ™
1. Plug the unit into an electrical outlet and press the power button to turn
on your HumidiHeat ™ unit.
2. Turn the mode knob to select the desired function. You may choose to use
either the heater, the humidifier, or the heater and humidifier together.
3. Once you have chosen the mode you can control how much air passes through
your HumidiHeat ™ unit by sliding the fan speed button to low, medium or high as
you prefer.
4. When you select either the heater mode or the heater + humidifier mode
you may control the amount of heat your HumidiHeat ™ produces. Choose
low, medium or high heat output.
CLEANING ANd MAINTENANCE
WARNING: Always unplug the humidiheat ™
unit prior to cleaning or other
maintenance.
CLEANING ThE hUMIdIFIER WICK FRAME:
1. Remove the humidifier wick frame as ex-
plained in the “ASSEMBLY AND USE”section
of this manual.
2. With the humidifier wick frame lying in front
of you, gently bend each side of the wick
frame to release the bottom roller.
See Figure 3.
3. Release the top roller from the frame by care-
fully bending back the frame bracket
and removing the roller axle from the bracket
hole. See Figure 4. Remove wick from rollers.
4. To clean the wick you may wash it in your
washing machine on a gentle cycle or use a
mild detergent to wash by hand. Rinse with
clean water. Be sure it is completely dry before reinserting.
5. Reinsert the humidifier wick into the rollers and then insert the humidifier
wick frame into the unit.
CLEANING ThE WATER TANK:
1. Remove the humidifier wick frame as shown previously.
2. Remove the water tank as demonstrated earlier in this manual. Clean the
tank with water and mild detergent.
3. Rinse thoroughly with clean water before reinstalling. Hand wash only.
STORAGE
Loop the cord around 6-8 inches and wrap with a cord tie. Place the unit in
the original box and store in a cool, dry place.
WARNING: Any servicing other than as described in this manual should
be performed by an authorized service representative. do
not wash the tank in the dishwasher.
TROUBLE ShOOTING
If you are having problems with your HumidiHeat ™ , please refer to the
following suggestions:
Problem: My HumidiHeat ™ unit will not operate.
Suggestions: • Make sure the power button is pressed and in the
down position.
• Make sure the unit is plugged into a functioning
power outlet.
• Verify the wick frame and the inlet grill are properly
installed.
Problem: My HumidiHeat ™ unit is not blowing as much air as it
used to.
Suggestions: • Verify that the fan speed is set correctly.
• Verify that nothing is blocking the air inlet grill or
outlet grill.
Problem: My HumidiHeat™ unit’s humidifier feature isn’t
working.
Suggestions: • Verify there is water in the tank
• Verify the humidifier water sensor is floating in the
water after filling tank.
• Make sure that the water tank is fully inserted.
Figure 3
Figure 4