Char-Broil 463620412 - Manual (Page 21)

9 9 Burner ,Firebox and Control Knob
Place burner assembly into firebox. Fasten the burner assembly to the firebox using 5x15 fiber washers and #10-24x1/2’’
machine screws. Insert #10-24x1-1/4’’ machine screws from outside the firebox, then fasten with #10-24 flange nuts
and 5x15 fiber washers from the inside( A ).
Place firebox on cart. Make sure burner tubes are correctly engaged with valves. If burner is not level from left to right,
adjust the two screws attaching valve to control panel. Attach ignitor wire to ignitor( B ).
Attach firebox with #10-24x2’’ machine screws, 5x15 fiber washers and #10-24 wing nuts( C) .
Push control knobs onto valve stems ( C ).
9
#10-24x1-1/4"
Machine Screw
Qty.4
#10-24x1/2”
Machine Screw
Qty.2
5x15 Fiber Washer
Qty.10
#10-24 Flange Nut
Qty.8
#10-24X1/2’’
Machine Screw
5x15 Fiber Washer
#10-24 Flange Nut
5x15 Fiber Washer
#10-24X1-1/4’’
Machine Screw
Control Knob
#10-24x2”
Machine Screw
Qty.4
Firebox
Burner assembly A
B
C
#10-24 Flange Nut
5x15 Fiber Washer
#10-24x2’’ Machine Screw
Heat shield
for Tank
Valve
Venturi tube
Ignitor wire
Make sure the Venturi tubes are located
underneath Heat Shield
21