EVE audio SC408 - User manual - Manual (Page 7)

SC 408
SC 407
EVE Audio product manual
Desk Filter Power Switch
12 13 OPERATION OPERATION
is too close to the loudspeakers or the room has reflective surfaces, it is
reasonable to attenuate the high frequencies.
3.11. Low and High Filter Combinations
0
+5
+3
-5
-3
100 1k 10k
dB
Hz
Attenuating the mids by boosting the high and low frequencies.
0
+5
+3
-5
-3
100 1k 10k
dB
Hz
Boosting the mids by attenuating the high and low frequencies.
3.12. Desk Filter
0
+5
+3
-5
-3
100 1k 10k
dB
Hz
The Desk Filter has two functions. When turned down it acts as a narrow-
band EQ set to 160 Hz (SC407 and SC408).
The reflections of mixers and similar surfaces usually result in the boosting
of low mids. With the Desk Filter you can lessen this effect by turning down
the filter gain.
When turned up, the Desk Filter also works as an EQ but this time set to 80
Hz. This allows you to give more punch to the lower frequencies.
! The following applies to all three filters:
• Every step represents a 0.5 dB increment.
• Maximal boost is +3 dB and maximal attenuation is –5 dB.
• Refer to the chapter on POSITIONING to set the filters of your EVE Audio
monitors effectively.
3.13. LED Mode
The LED mode determines in which of the four available fashions the LED
ring displays the volume level. The LEDs represent given levels, which are
displayed and adjusted according to four steps. Intermediate steps are
indicated by the brightness between two adjacent LEDs.
• Bright Ring
All LEDs up to the selected volume level light up brightly. The louder the
signal, the longer the brightly lit-up ring.
• Bright Point
Only the LEDs corresponding to the selected volume level light up brightly.
The louder the signal, the further up the brightly lit-up point moves.
• Dimly Lit Ring
All LEDs up to the selected volume level light up dimly. The louder the
signal, the longer the dimly lit-up ring. In this mode, the LEDs light up
brightly momentarily while you adjust the volume level.
• Dimly Lit Point
Only the LEDs corresponding to the selected volume level light up dimly.
The louder the signal, the further up the dimly lit-up point moves.
! Intermediate steps are indicated by the lighting of two adjacent LEDs. The
level ranges from -60 dB to +10 dB, taking „0 dB“ as reference point.
3.14. Saving Your Settings
All settings on the front and rear panels are automatically saved. The
loudspeakers can be disconnected anytime without the settings being
lost.
3.15. Power Switch
The power switch on the rear panel disconnects the loudspeaker