EVE audio TS112 - User manual - Manual (Page 5)

TS 108
TS 110
TS 112
TS 107
EVE Audio product manual
Volume Mode Sat. Filter
8 9 OPERATION OPERATION
-80 dB 0 dB
-8 dB
-12 dB
-20 dB
-48 dB
1 Step = 2 dB
(1 LED = 4 Steps)
1 Step = 1 dB
(1 LED = 4 Steps)
1 Step = 0.5 dB
(1 LED = 4 Steps)
1 Step = 0.5 dB
(1 LED = 4 Steps)
1 Step = 0.5 dB
(1 LED = 2 Steps)
Both controls feature the exact same response curve, which is not linear.
The increments become finer as the volume increases:
-80 dB (minimum) to -48 dB:
2 dB
-48 dB to -20 dB: 1 dB
-20 dB to 0 dB (maximum): 0.5 dB
• Subwoofer Mute
To Mute the subwoofer, press briefly the Subwoofer Volume control. All
LEDs will turn off, except for the left-most LED, which lights up dimly.
! To exit the Subwoofer Mute mode press the Subwoofer Volume control
once again. The subwoofer will return to the volume level it had before
being muted.
• System Mute
To Mute the whole system (subwoofer + satellites), turn the System Volume
control counter clockwise until you reach the minimum level. When the
LED on the left end of the System Volume control lights up dimly the Mute
mode is activated.
! To exit the System Mute mode simply turn the System Volume control
clockwise until you reach the desired volume.
3.5. Settings Menu
Additional status LEDs on the front panel plus infrared sensor
Press the System Volume control once to enter the Settings menu. Here
you can set two different filters (Sat. Filter and Sub Filter), as well as the
phase of the subwoofer and the behavior of the volume controls’ LED
rings. The LED of the currently active function will blink.
Turn the System Volume control to choose the filter, phase or LED mode
desired. The blinking LED indicates the function selected, while the steady-
on LED indicates the value assigned to that function.
Press the System Volume control to confirm your selection. The blinking
will stop once the selection is confirmed.
Turn the System Volume control to adjust the filter, phase or LED behavior.
When you are satisfied with the setting press the System Volume control
again to go back to the Settings menu. You can then select and edit
another function.
! To exit the Settings menu press and hold the System Volume control for
three seconds or simply wait 10 seconds. The subwoofer will then return
automatically to the Volume mode.
3.6. Filter
The filters of the EVE Audio subwoofer were specially developed to offer
you the possibility of adjusting your subwoofer to the characteristics of
your system. These filters help control the overlapping of frequencies
between the subwoofer and the satellites. The goal is to optimize the
sound image to the room acoustics and to a given listening distance.
3.7. Sat. Filter
The Sat. Filter is a high-pass filter that can be used to filter out all content
below 80 Hz from the L + R outputs going to the satellite speakers. Use this