E-Ware EW-8K129 - Manual (Page 5)

4
rotating.
5. Do not operate the juicer for more than 40 seconds at a time when juicing heavy loads. Let it
cool down sufficiently between uses. None of the recipes in this user manual constitute
heavy loads.
6. Do not remove the pulp container when the appliance is operating.
7. Always unplug the appliance after use.
\
PREPARING FOR USE
1. Wash all detachable parts (see chapter on ‘Cleaning’).
2.
Pull the electric cord out of the cord storage compartment at the back of the appliance. Place
the juice collector into the appliance. Place the pulp container by tilting it forwards slightly. Insert
the top end of the pulp container first and then push the bottom end.
3. Do not empty the pulp container while you are juicing. Switch off the appliance and carefully
remove the pulp container.
Note: Reassemble the empty pulp container before you continue juicing.
4. Put the filter in the juice collector. Hold the lid over the filter and lower it into position
5. Make sure the filter and juice collector are fitted securely onto the drive shaft (‘click’)
6. Snap the clamp onto both sides of the lid to lock it into place (‘clicks’). Align the groove in the
pusher with the small protrusion on the inside of the feeding tube and slide the pusher into the
feed
7. Place the lid on the juice jug to avoid splattering or if you want to store juice in the refrigerator.
8. Place the juice jug under the spout
USING THE APPLIANCE
The appliance will only function if all parts have been properly assembled and the lid has been
properly locked in place with the clamps (See Fig. B).
1. Wash the fruit and/or vegetables and cut them into pieces that fit into the feeding tube.
2. Make sure the juice jug has been placed under the spout.
3. Turn the control knob to speed setting I (high speed) or II (normal speed) to switch on the
appliance.
z Speed II is especially suitable for soft fruits and vegetables such as watermelons, grapes,
tomatoes, cucumbers and raspberries.
z Speed I is suitable for all kinds of fruits and vegetables.
4. Put the pre-cut pieces in the feeding tube and gently press them down towards the rotating
filter with the pusher.
5. Do not exert too much pressure on the pusher, as this could affect the quality of the end result
and it could even cause the filter to come to a halt.
6. Never insert your fingers or other object into the feeding tube. Only use the pusher for this
purpose.
7. After you have processed all ingredients and the juice flow has stopped, switch off the