Practical advice, Repairing – E-Ware EW-6K205 User Manual
Page 4
Step 1
Step 2
Step 3
100℃ 160℃ 230℃
Choose the appropriate temperature as required.
Switch on the knob to step 3, the heating pilot light is on and the heating element
begins to work.
When the temperature of the turnplate reaches between 220-240
, the heating
℃
pilot light goes off. The heating element stops working while the turnplate keeps
rotating.
When the turnplate cools at a certain stage, the heating pilot light goes on and the
heating element starts working again.
Normally it takes 6-8 minutes to make a pizza.
When cooking finishes, turn the controller to the OFF position, unplug the
appliance and open the lid.
Carefully place the pizza onto a cutting surface that is heat resistant. Never cut
the pizza on the pizza pan. This will damage the pan.
When the appliance stops working, both the heating pilot lights are off.
3. Cleaning
Turn the controller to the OFF position and unplug.
Completely cool the pizza maker and pan before removing or attempting to clean.
Wash the pizza pan in warm, soapy water. Rinse and dry.
Never use abrasive pads or alcohol.
Wipe the pizza oven and cord with a clean damp cloth. Do not immerse the pizza
maker in water or any other liquid.
Dry all parts thoroughly before storing.
Practical advice
Rising crust pizzas: Over cooking a pizza may cause the rising crust to touch the
upper heating element. This may cause the crust and toppings to scorch. Rising crust
pizzas must be carefully watched to prevent this from happening.
When making a fresh dough pizza, always oil the pizza pan with vegetable oil or
cooking spray to prevent the dough from sticking.
The largest crust the pizza maker will accommodates is 11 inches. Be sure that the
crust does not hang over the edge of the pizza pan. If the crust touches the sides of
the cover the pizza maker will not turn and the pizza will not cook. (Trim or cut your
pizza so that it fits properly on the pan.)
Repairing
:
If there is any breakdown or damage, the appliance must be repaired by specialized
people.Non-specialized people are not permitted to dismantle or repair the appliance.