Fleet Engineers INS-97001 - Manual

Quarter Fender
Mounting Instructions
50-foot pounds of torque is needed on the steel clamp
and 75 foot pounds of torque is needed on the stain-
less clamp. This torque is to be applied to the nut
instead of the bolt. When this torque is applied, the
flange end of the clamp should touch.
Recommended quarter fender mounting will
result in maximum fender & top flap product life.
Installation Sheet # INS-97001
Installation Sheet # INS-97001 • 97 • Rev. E 12/06
.50" Minimum • 2.00" Desired
PLASTIC:
3.5" Minimum
4.5" Desired
METAL:
3" Min. S.A.E.
Recommended
Clearance
Allowable
Space Between
Fender & Tire
Mount quarter fender so top of flap is
lower than top of level fifth wheel.
IMPORTANT:
Always allow for maximum suspension deflection.