Curtis Mathes CM19102 - Manual (Page 17)

Changing the TV's Input
Normally, your TV displays the signal coming through the antenna terminal. However, If you’ve
connected another component to your TV(such as a VCR) using the Video/Audio input, you will
want to be able to view the signal from the component.
To do this, you will need to switch from the ‘TV’ input to the ‘ Line ‘ Input, as follows.
1 With the TV on, press the MENU button twice, then “ Set-Up “ menu will appear.
2 Use the VCHW buttons to select “ Input “.
3 Press the CVOLB buttons to change from ‘TV’ to ‘ Line ‘.
4 Wait 10 seconds, or press the MENU button to return to normal TV viewing.
When connecting an Video/Audio cable from the Video/Audio out jack on the VCR to the
Video/Audio in jack on the front of your TV, and your TV’s back panel at the same time, the former
takes precedence over the latter.
Select
Set-Up
Language : English
Reception : Air
Memorize Channels
Add/Delete Channels
Input :
TV
Adjust Next
1
Select
Set-Up
Language : English
Input :
Line
Adjust Next
3
Select
Set-Up
Language : English
Reception : Air
Memorize Channels
Add/Delete Channels
Input :
TV
Adjust Next
2
14 Chapter 3 : Operating Your TV