Flintec FAA-27 - Manual (Page 20)

FAA-27, Technical Manual, Rev. 1.1, June 2014
Page 19 of 21
8. Programming With xFace Software Over RS232
FAA-27 has RS232C serial interface to perform eCal electronic calibration and to
adjust filter, setpoint values and to follow status by using xFace software installed on
a PC.
For installing the xFace software, which is supplied with the instrument or can be
downloaded from
www.flintec.com , follow the steps described below.
8.1 Installation Of xFace Software

Close all applications on your PC

Insert the CD that contains the xFace software v2.03 or higher into the CD-
ROM drive

D ouble click “Setup.exe” to start the installation. The setup Wizard will be
displayed.

Follow the menus in the setup wizard step by step.

After finishing the installation, the Setup Wizard will inform you about the
success of the software installation. Click the OK button.

After closing the Setup Wizard you can start to use the xFace software.
8.2 Connection To The xFace Software
For programming instrument via xFace follow the instructions below;
1. Power off the instrument.
2. Connect the instrument to PC as
shown in chapter 4.5 to use xFace
software and run the software.
Select FAA-27 and press
“OK”
button.
3. Select the Com-port and press on
“Connect” to connect to the
instrument.