Futaba 2NBR - Manual (Page 3)

CONTENTS AND RATINGS
Ratings are subject to change without prior notice.
Transmitter
Receiver
Servo
Battery holder
Others
FP-T2NBL x 1
FP-R102GFx 1
FP-S128x2
R2-BSS-N x 1
FP-T2NBR x 1
FP-R102GF x 1
FP-S128x2
R2-BSS-N x 1
FP-T2NBFR x 1
FP-R102GF x 1
FP-S128x 2
R2BSS-N x 1
Switch, frequency flag, spare horn
Transmitter FP-T2NBL/T2NBR T2NBFR
Operating system
Transmitting
frequency
Modulation
Power requirement
Current drain
2 nick
27MHz, bands 1 to 6 72, 75MHz
AM (Amplitude Modulation)
12.0V, penlight battery x 8
170mA
Control system
Operating angle
Power
requirement
Current drain
(IDLE)
Output torque
Operating speed
Dimensions
Weight
pulse width control
One side 45° or more
4.8V -6
6.0V. 8mA (at Idle)
48.7 oz.in. 13.5 kg-cm)
0.24 sec/60
1 6 x 0 8 x 1.6 in.
(40.5 x 20 x 40.5mm)
1.92oz. 153g)
SERVO FP-S128 Receiver FP-R102GF
Receiving
frequency
Intermediate
frequency
Selectivity
Receiving range
Power supply
Dimensions
Weight
27MHz band. bands 1 to 6
72. 75MHz
455kHz
3kHz/-3dB
550 yards (500m) on the ground
when used with FP T2NBLIA1 the
best radio wave condition of
environment)
4.8V to 8 4V
7.2V/13mA. 4 8V/33mA
1.46 x 2 . 1 9 x 0 . 7 5 in
(37 x 55.5 x 19mm)
1.34 oz 138g)
BEC & ASP functions
TRANSMITTER FP-T2NBL/T2NBR/T2NBFR
• Nomenclature
•The name of each part of the transmitter is
shown in the figure. Learn them before ope-
rating your set.
When running the vehicle, extend the antenna
fully.
Before using the set, check the remaining
battery capacity by checking the level meter.
Good Caution No good
Change the battery.
2
Servo reverse switches
(NEW ATTACK-R, NEW ATTACK-BFR)
Handle
Level meter Antenna
Frequency flag
Neutral lever
Throttle trim
Throttle stick
ASP setting
trimmer
ASP setting
switch
(NEW ATTACK-BFR only)
Transmitter
crystal holder
Power switch
Steering trim
Steering stick
Hook