Futaba 3PM FM, FS, FS Pro - Manual (Page 44)

45
Functions
Channel 3 Position / CH3
Use this function to set the servo position of the channel 3.
This setting is linked to transmitter switch (SW2). When the switch is assigned to
another function, set the channel 3 position with this screen.
Adjustment buttons
- Use the (+) and (-) buttons to make
adjustments.
- Press the (+) and (-) buttons simulta-
neously (approx. 1 sec) to return to
the initial screen.
(Initial screen)
Press "SEL" key to select the
desired function screen.
Calling the setup screen
(Setup screen)
When channel 3 switch is operated,
t h e " C H 3 " s c r e e n i s d i s p l a y e d
automaticaly for about three seconds.
Channel 3
position
Channel 3 position
L.F.U 100% ~ 0 ~ R.B.D 100%
Initial value: 0%
Setup Item
RATE: Channel 3 posiion
Channel 3 adjustment
(Preparation)
- Select setup item "CH3" and make the following ad-
justments.
1
(Position adjustment)
Use the (+) and (-) buttons to adjust the channel
3 position.
- This position is linked with the switch (SW2).
2
When ending adjustment, return to the initial
screen by pressing the (SEL) button.
ATL position
0 ~ 100%
Initial value: 100%
Setup Item
ATL-BK: Throttle ATL position
Throttle ATL adjustment
1
(ATL position adjustment)
Use the (+) and (-) buttons to adjust the ATL position.
- This position is linked with the grip lever (DT4).
2
When ending adjustment, return to the initial screen by pressing the (SEL)
button.
Adjustment buttons
- Use the (+) and (-) buttons to make
adjustments.
- Press the (+) and (-) buttons simulta-
neously (approx. 1 sec) to return to the
initial screen.