Futaba R304SB - Manual (Page 2)

FUTABA CORPORATION
1080 Yabutsuka, Chosei-mura, Chosei-gun, Chiba-ken, 299-4395, Japan
Phone: +81 475 32 6982, Facsimile: +81 475 32 6983
©FUTABA CORPORATION 2013, 4 (1)
Compliance Information Statement
(for U.S.A.)
This device, trade name Futaba Corporation of America, model number R304SB, complies
with part15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
(3) This module meets the requirements for a mobile device that may be used at separation
distances of more than 20cm from human body.
To meet the RF exposure requirements of the FCC this device shall not be co-located with
another transmitting device.
The responsible party of this device compliance is:
Futaba Service Center
3002 N Apollo Drive Suite 1, Champaign, IL 61822 U.S.A.
TEL (217)398-8970 or E-mail: [email protected] (Support)
R304SB Specifications:
( T-FHSS system, S.BUS2, 4-channel receiver)
• Receiving on 2.4GHz band
• System:
T-FHSS system
At Normal/High speed mode (auto detection)
• Power requirement Rated voltage: 4.8V-7.4V / Usable voltage: 3.5-8.4V
• F/S and Battery F/S function:It is set according to the transmitter used.
• Battery F/S voltage: Set it with the transmitter arbitrarily.
• Size: 1.38x0.91x0.33” (35.1x23.2x8.5mm)
• Weight: 0.23oz. (6.6g)
2
Receiver HUB
Temperature
sensor
RPM sensor
Voltage sensor
Switch
Battery
Telemetry sensors
(Option)
Steering servo
Throttle servo
CH4
CH1
S.BUS2
CH2
(It connects with port which is not used.）
*When all the ports are used, connect
a battery using HUB or Y-harness.
The Example of Connection