Futaba GY502 - Manual (Page 24)

24
D
ATA
S
ETTING
When Using a T9Z Transmitter Programmable Mixing
The Programmable Mixing (PMIX) function lets operator perform a gain
adjustment at each condition. Set the sensitivity at all conditions.
[GY502 Settings]
Select the gyro operation mode at the GY502 Mode screen. (AVC, NOR, or
CMT)
[Transmitter Settings]
Function Control:
Set the CH5 (GYR) switch to “NUL” at the transmitter Function Control
(FNC) setup screen.
ATV function:
Adjust both the RATE A and RATE B rates to 120% at the transmitter ATV
function setup screen.
Programmable Mixing function:
1. Select the “ACTIVE” mode (ACT) at the transmitter Programmable Mixing
setup screen.
2. Set the mixing type to “OFS”.
3.Set the slave channel to “GYR”.
4. Set the sensitivity rate (RATE).
(The following page shows a setting example in the CMT mode.)
[Sensitivity Display]
The gain display indicates the actual gain at the GY502 normal screen
display.
The following shows the relationship between transmitter and gyro setting
when GY502 sensitivity setting is 100% in both the G1 and G2 gain modes.
- Relationship between transmitter and gyro setting
Transmitter
settings
GY502mode
settings
Actual gain
NOR
AVC
CMT
-100% - 0% - +100%
Normal mode
AVCS mode
Normal mode AVCS mode
(G2) (G1)
100% - 0% - 100%