Futaba GY701 Quick Start - Manual (Page 14)

F
INISHING
U
P
14
Ensure that all extensions and servo wires are
attached and bundled within the helicopter and that
everything is plugged in correctly. Before the test
fl ight verify all settings and ensure that the gyro
compensates the proper direction.
Ensure that:
❑ the Transmitter and Receiver batteries are fully
charged.
❑ the gyro mounting pads are in good condition.
❑ the gyro wiring has some slack in it and all wires
are clear of the main frame.
❑ the GY701 servo type parameter matches the
servo you are using.
❑ the tail rotor servo arm is perpendicular to the
pushrod and the pitch slider is centered.
❑ the servo does not bind when full left or full right
tail rotor is applied.
❑ the gyro is operating in the correct mode (AVCS
or Normal).
❑ the tail rotor stick operates the tail rotor the correct
direction.
❑ the gyro compensates the correct direction when
the helicopter is rotated.
❑ the gain is set correctly and the gyro operates
in the correct mode (AVCS or Normal) in every
fl ight condition.