Cooper Lighting AMETRIX ADY071480 - Manual

Warning : Before starting any work ensure
that all sources of power are turned off. All
work must meet local/national codes and be
performed by a certified electrician. Do not
mount fixtures vertically.
Installation Instructions
Vault C-Scroll Roundel
These installation instructions are valid with the above Ametrix styles.
1
3 2
Sheet 1 of 3
Large, INDOOR
CR
(Cantilever, Remote ballast)
Visor and Non-Visor
ADY071480 REVA(ECN080352)
Mounting cantilever to structure
J-box
(by others)
#8-32 x3/8"
Set screw
Canopy
Mounting plate
1/4" fastener
(by others)
(4x)
Wiring the fixture
Use additional bracing around
J-box to support J-box.
Exploded view and part call-out
Canopy
#8-32 x3/8"
Set screw
(2x)
Fixture head
#10-32 x1
End screw
(2x)
Yoke end cap
Yoke assembly
1/4-20 x3/4"
Hex bolts
(2x)
1. Prior to attaching fixture head to cantilever, remove both
#8-32 x3/8" set screws and allow canopy to slide down
pendant.
2. Feed power wire through wiring holes and using appropriate
fasteners, secure mounting plate to structure. Use additional
bracing around J-box to support J-box.
Attention:
All large fixtures require additional bracing/structure
around J-box to support fixture.
1. After pulling wires through wiring holes in mounting plate,
attach appropriate wires and ensure all connections are
properly matched.
2. Push connections into J-box and secure canopy using both
#8-32 x3/8" set screws.
3. Refer to supplementary sheet for instructions on aiming and
sealing the fixture.
#8-32 x 3/8"
Set screws
(2x)
Wiring holes
Canopy
Securing fixture to cantilever
1. To remove fixture head from yoke assembly, remove #10-32
x1 end screw from one side.
2. Remove the #6-32 x 1/4" Flat head screw from the inside of the
yoke arm and remove the yoke end cap.
3. With fixture head removed, secure yoke to cantilever using
1/4-20 x 3/4" hex bolts.
4. Run wiring from fixture head, into pendant and out holes in
mounting plate.
#10-32 x1
End screw
Yoke arm
end cap
Fixture head
#6-32 x1/4
Flat head screw
1/4-20 x3/4"
Hex bolts
(2x)