Alpine 7909 - Manual (Page 7)

IN CASE OF DIFFICULTY
CD CHANGER MODE (when used with the Alpine CHA-S604 or CHM-S601)
No CD functions. DIN Control cable not
connected.
Make sure the cables for
control and audio have been
properly connected per the
CD Changer manual.
The CD magazine has not
been inserted. Install the magazine with at
least one CD inserted.
Music skips exces­
sively.
The CD Changer has not
been mounted securely.
Follow the installation instruc­
tions in the CD Changer
manual for proper installation.
The transit screws were
not removed before
installation.
Remove the Transit Screws
and reinstall the changer.
The mounting angle of the
CD Changer is exces­
sive. Remount the CD Changer
according to the directions
given in the installation
manual.
The CD being played is
dirty. Clean the CD being very
careful not to scratch it.
The CD being played is
damaged.
If the CD in question is
cracked or warped, discard it
as it could cause damage to
the CD mechanism: if the CD
is scratched at one selection
only, skip that selection using
the Music Sensor function to
play the remaining selections.
Playback of 3" discs
does not work.
The 3" adaptor ring is not
being used.
Place the 3" adaptor ring onto
the disc before inserting into
the CD magazine.
26
FEATURES
• FULL FRONT DIN™
• CD CHANGER CONTROLS (when used with the Alpine CHM-S601 or CHA-S604)
• DUAL PRE-AMP OUTPUTS
This allows you to easily expand your system by providing Front and Rear Preamp
Outputs and a Pre-Amp Fader.
<COMPACT DISC PLAYER FEATURES>
• 8 TIMES OVERSAMPLING DIGITAL FILTER
• 18-BIT, DUAL DIGITAL-TO-ANALOG CONVERTERS
• POWER LOADING/SELF LOADING
The mechanism gently pulls the partially inserted compact disc into the play position
and begins playback.
• MUSIC SENSOR UP/DOWN
For locating the beginning of the next track (up), or the track currently in playback
(down).
• FAST FORWARD/FAST BACKWARD
• M.I.X.
When the M.I.X. button is pressed, the microprocessor inside the 7909 will randomly
select tracks for playback. After all tracks have been played, the M.I.X. feature will go
into the Repeat Mode and begin again.
• C.D.S. (Compact Disc Straight)
Pressing the CDS button bypasses the tone and balance control circuits to play back
very clear, natural and dynamic CD sound. This ensures that fewer analog compo­
nents will contribute to the noise level of the digital-to-analog conversion.
• REPEAT
• 3-INCH DISCS
This unit plays 3-inch compact discs without using an adaptor ring.
• EJECT AUTO-LOCK
This locks the laser mechanism when a disc is ejected.
• DISC SCAN
Locates the beginning of each track and plays the first 10 seconds.
• ELECTRONIC EJECT/RELOAD
• PAUSE
<RADIO FEATURES>
• T-10 II TUNER
Alpine's premier tuner utilizes a number of innovations to ensure stable, noise-free FM
reception in both strong and weak signal areas.
• A. MEMO (AUTO MEMORY)
In the Auto Memory mode, the 6 strongest FM or AM stations will be stored automati­
cally.
• D.A.P. (DIRECT ACCESS PRESET)
D.A.P. allows the storage of AM and FM presets on the same band, eliminating the
need to press the TUNER/BAND button. Up to 6 FM and AM stations can be mixed in
the D.A.P. Band.
• ETR/PLL DIGITAL FREQUENCY SYNTHESIZER
• LITETOUCH™ 24-STATION PRESETS
6 FM1, 6 FM2, 6 AM, 6 D.A.P.