Philips BG2040 - Manual (Page 8)

Cleaning
I The Groomer should be cleaned after each use.
I Always switch Groomer OFF and remove
power cord from charging stand and outlet
before cleaning.
I Do not use compressed air, abrasive
cleaning agents, scourers or liquids such as
alcohol, benzene bleach or acetone to clean the
appliance.
I Never clean, remove or replace shaving head
assembly while motor is on.
I Do not apply pressure to shaving head. Do not
touch foil with hard objects as this may dent or
damage foil or cutters. If damage occurs, replace
damaged parts.
I Do not use Groomer if foil, cutters or trimmers
are damaged or broken as injury may occur.
I Only use the cleaning brush supplied. Any other
brush may cause damage.
Cleaning the shaving unit
D
Always switch Groomer OFF, remove the
power cord from outlet and charging stand
before cleaning.
B Remove the shaving foil head by pulling it off
the appliance (Fig. 14).
Hold the shaving head by the plastic housing only.
B
Rinse the shaving unit under warm running
tap water to rinse away debris (Fig. 15).
Do not use the cleaning brush to clean the
shaving unit as this may cause damage to the foil
or cutters.
□ Clean the hair chamber with the cleaning
brush. You may also rinse the hair chamber
under warm running tap water to remove any
residual debris (Fig. 16).
H Do not use a towel or cloth to dry shaving
foil or cutters as this may cause damage: allow
to air dry thoroughly.
□ Reattach the shaving head by snapping it back
onto the Groomer (Fig. 17). You will hear a
‘click’.
B
Rinse the Groomer body under running warm
tap water. Wipe dry with a soft clean towel
or cloth.
Cleaning the trimming unit
D Always switch Groomer OFF, remove the
power cord from outlet and charging stand
before cleaning.
B
Remove the trimming comb by sliding it off
the Groomer.
B Push the middle part of the trimming unit
upwards with your thumb until it opens
(Fig. 18).
D Remove hairs from the hair chamber with
the supplied brush (Fig. 19). You may also
rinse the hair chamber under warm running
tap water to remove any residual debris.
H Rinse the trimming unit with warm running
tap water (Fig. 20).
Q After cleaning, close the trimming unit and
reattach the trimming comb (Fig. 21). You
will hear a ‘click’.
B
Rinse the Groomer body under running
warm tap water. Wipe dry with a soft clean
towel or cloth.