Combi 8000 Series - Manual (Page 16)

15
Attach car seat to base.
Adjust recline using recline indicator on the side of the car seat. Line of recline indicator
MUST be in green striped zone (fig. e). If line is not in green striped zone, adjust base
(see “Base Adjustment” section), and recheck recline of car seat. Repeat until recline
indicator is in green striped zone.
If base can not be adjusted to locate the line in the green striped zone:
1. Try a different seating position.
2. Do not use this infant car seat.
NOTE: Vehicle must be parked on horizontal surface during this installation.
Remove car seat from base.
With hook-on connector opening facing down , position the opening of the
connector over the vehicle lower anchorage. Push down and then pull out on the
connector to lock it onto the vehicle anchorage (fig. f). You should hear a click.
Pull on connector to be sure it is locked onto the anchorage.
Repeat for connector on opposite side.
Tighten lower anchorage belt to secure the base. Press down in center of base to depress
the vehicle cushion and pull free end of lower anchor belt to tighten belt around base
(fig. g).
Check for secure installation. Pull base front to back and left to right
to check for secure installation (fig. h). LATCH belt MUST stay tight.
If LATCH belt does not stay tight or base can not be securely installed,
try a different LATCH location or use the vehicle’s seat belt to secure
the base.
Attach car seat to base.
Recheck recline of car seat. Adjust if necessary (see step 9).
(fig. f)
(fig. h)
(fig. e)
8
9
10
11
12
13
14
15
2
3
1
2 3
1
(fig. g)
TICS1203e (EN).qxd 4/4/05 4:15 PM Page 16