FXpansion Japanese Taiko Percussion - Manual (Page 8)

Important : We strongly recommend that you choose the “Full” install size when installing JTP. The
“Full” install size is the most appropriate for reproducing exquisite taiko stick work. After installation,
you can choose the size from High, Medium, Small, Minimum when loading kit pieces into BFD.
JTP can be installed with one of three detail levels, determining the maximum amount of velocity
layers that are installed for each kit piece.
Full : a maximum of 127 velocity layers will be installed (6 GB)
Medium : a maximum of 40 velocity layers will be installed (5.68 GB)
Small : a maximum of 20 velocity layers will be installed (4.08 GB)
The installer will install the following components on your system.
Audio folders containing 12 kit pieces:
Ohdaiko A & B, Chudaiko A & B, Shimedaiko1 A & B, Shimedaiko2 A & B, Kane, Taiko Voice
A, B & C
Two BFD2 presets:
JTP Taiko, JTP Taiko Low Tuning
One dedicated taiko key map:
JTP Taiko
Two kits:
JTP Taiko, JTP Taiko Low Tuning
12 kit pieces:
Ohdaiko A & B, Chudaiko A & B, Shimedaiko1 A & B, Shimedaiko2 A & B, Kane, Taiko Voice
A, B & C
Two mixers:
JTP Taiko, JTP Taiko Low Tuning
Grooves : four palettes and 60 exclusive grooves
Please see Section 5-2 and the BFD2 manual for more information about presets, key maps, kits, kit
pieces, mixers, and grooves.
*There is little difference between the “Full” and “Medium” install sizes because JTP has a maximum
of 47 velocity layers. Therefore, please choose “Full” if you have sufficient system resources.
*The more velocity layers, the more CPU, RAM, and hard disk resources used. The “Small”
installation is recommended for systems with less than 1 GB of RAM.
4. Choose the Install Size
5. Installed Components