GME SPK008B - Manual (Page 2)

InstallatIon InstructIons
SPK008 TECHNICAL SPECIFICATION AND CUTTING TEMPLATE SPK008
The wake tower speaker is designed to hang from a wake
tower of diameter ranging from 40–50 mm (1.5”–2”).
attachIng the speaker to the Wake toWer
1. Remove both nuts holding the top plate onto the
bracket using a 4.75 mm (0.2”) allen key.
2. Remove the top plate.
3. Place the speaker and the top of the bracket around the
wake tower in desired
position. Screw in the nuts.
4. Ensure the speakers are facing in the desired direction
and tighten.
Once the speaker has been attached to the wake tower, the
speaker cables can be attached.
speaker cable WIrIng
1. Take the two (2) supplied rubber grommets and snip off
the end so a hole the diameter of your speaker cable
is made. GME recommends the use of 6–10 mm (0.2”
–0.4”) speaker cable depending on the cable run to
your stereo or amp.
2. Place the rubber grommet over the end of the speaker
cable. This needs to be done twice for each terminal on
the speaker.
3. Once the grommets have been placed over the speaker
wire, attach the wires to the terminals on the back of
the speaker.
4. Ensure the positive speaker cable is attached to the red
terminal and the negative speaker cable is attached to
the black terminal.
5. Slide the rubber grommet over the terminal, ensure the
whole of the terminal is covered.
6. Connect the other end of the speaker wire to your amp
or stereo system.
Speaker wire diameter
Grommet
Terminal
Speaker Wire
Self-adhesive
rubber pad