Golden Lighting 3086-4P CH - Manual (Page 2)

Fig. 2
PARTS & ASSEMBLY SHEET
Fixture Name: Athena 3086-BP4 CH
For Customer Service, contact the place of purchase to arrange for replacement parts.
ASSEMBLING THE FIXTURE (Fig. 2)
2. Measure to determine the correct number of
links needed for proper hanging height. Use a pair
of pliers to open one link of Chain (K). Remove
and discard excess Chain (K).
3. Use one Chain Connector (L) to attach one end
of the chain toTop Loop (J) then close the chain
connector.
4. Feed the fixture wires through the chain (every
three links) and pull the wires until taut.
5. Slip Canopy Loop Collar (H) over the chain,
then do the same with Canopy (G).
6. When ready to complete the installation, use
the remaining chain connector to attach the other
end of the chain to Canopy Loop (F). Then close
the chain connector.
7. Make sure the weight of the chandelier will be
supported by the chain-not the electrical wire.
* You may now install the fixture.
Note: Complete these remaining steps after the
fixture is hung.
E
D
A
C
B
H
L
K
G
J
M
Q
P
N
O